Luvion ICON CLEAR 75 PRO Manuel D'instructions page 10

10
Warning: Only use the power adapters supplied. Using incorrect power adapters may
permanently damage your product.
1.2 Battery low alert on Parent unit
When the batteries on your Parent unit are running out, an alert will sound and the
battery icon on your display screen will fl ash. When this happens, you'll need to charge
the batteries.
If you ever need to remove the batteries, slide open the battery compartment cover
and use the ribbon to push them out.
Warning: Always use rechargeable batteries in the Parent unit. Only use the type we've
recommended – 2 x AA NiMH 1300mAh batteries. Charge the batteries as instructed in
this user guide. The Parent unit can still be used when it's charging.
2. BABY UNIT SETUP
2 .1 Setting up
1.
Plug the remaining power cable into the socket on the back of the Baby unit.
2.
Plug the other end of the cable into your mains wall socket and switch it on. (fi g. 4)
2.2 Switching on and linking the Parent and Baby units
Before switching on, make sure the Parent and Baby unit are at least one metre from
each other. Any closer and you might get audio feedback sounds.
1.
Press and hold the
fl ashes.
2.
Press and hold the
briefl y light up. The orange Link indicator will fl ash and the display will show "I'm
Linking..." When the units are linked, the orange Link indicator lights on the Par-
ent and Baby units will stop fl ashing. When the lights stay steady, your monitor is
ready to use.
2.3 Deciding where to put your units
The Baby unit should ideally be within 1 to 2 metres of your baby. Make sure both the
Baby unit and mains power cable are connected securely and they're out of baby's
reach. If the Parent and Baby units are too close together, you'll hear a high-pitched
noise. That's because the units are designed to be put at a distance from one another,
such as in separate rooms.
Important: The two units will need to be linked before you can start using them. If the link
between the units is broken, the Link indicator lights will fl ash while they try to look for each
other and The Parent unit will show "I'm Linking...". After 30 seconds, if the link is still broken,
the Link indicator lights will fl ash red and the Parent unit display will show "Not Linked". If
the link is broken, check that:
•
the mains power is plugged in and switched on at the Baby unit
•
both units are switched on
•
the batteries are charged in the Parent unit
•
the Parent and Baby units are within range of each other (in ideal conditions, that's up
to 330 metres outdoors and 50 metres indoors).
3. USING YOUR LUVION ICON CLEAR 75 PRO AUDIO BABY MONITOR
3.1 Switching the Baby unit on
1.
1. Press and hold the
button on the Baby unit until the orange Link indicator
button on the Parent unit until all the LEDs on the unit
button, the orange Link light fl ashes. When it's fi nished