Battery Replacement - Simons Voss Technologies ST20.080070 Guide Abrégé

7. Battery management
NOTE
Battery warning disables programming mode
Programming mode cannot be used during an active battery warning.
All functions for which programming mode must be entered are
blocked.
1. Replace the battery (see
2. Reset the battery warning.
9

7.2 Battery replacement

ü
1. Unscrew the screws holding the cover in place.
2. Remove the cover.
3. Using a screwdriver, slide one side of the battery clips into the open-
IMPORTANT
Jumping out due to spring tension of clamps
Clamps are under tension. They may jump out and be lost when
loosening.
36 / 144
Programming mode is accessible again.
Screwdriver present (Torx TX6).
ing provided.
Battery replacement [
PIN code terminal
}
36]
).
EN