Repair Parts - Flotec PROFESSIONAL FPSE9050 Notice D'utilisation

Troubleshooting • Repair Parts
Sudden Starts . If power to pump is on when thermal overload resets, pump may start without warning. If
you are working on pump, you may get an electrical shock or impeller may catch fingers or tools. Disconnect power
before servicing pump.
Check to be sure that power cord is securely plugged into outlet. Disconnect power to outlet before handling pump or motor.
Check to be sure you have electrical power.
Check that liquid fluid level is high enough to activate switch or controller.
Pump fails to operate:
Check to be sure that 3/16" (4.7 mm) vent hole in discharge pipe is not plugged.
Check for blockage in pump inlet, impeller, check valve or discharge pipe.
Thermal overload may have tripped. Test start pump; if it starts and then stops immediately, disconnect from power source for
Be sure all valves in discharge pipe are fully open.
Clean out discharge pipe and check valve.
Pump fails to empty sump:
Check for blockage in pump inlet or impeller.
Pump not sized properly. A higher capacity pump may be required.
Check switch or controller automatic floats for proper operation and location. See installation instructions for switch/controller.
Pump will not shut off:
If pump is completely inoperative or continues to malfunction, consult your local serviceman.
Performance
5 (1.5m)
8400 (31,798)

Repair Parts

Power Cord .......................................... PW117-281-TSU
Automatic Float Switch ................................ 141050001
Impeller ......................................................... 21542B000
Lower Volute .................................................24638D000
For parts or assistance, call Flotec Customer Service at 1-800-365-6832
All manuals and user guides at all-guides.com
30 minutes to allow motor to cool, then reconnect to power source. Check for cause of overheating/overloading.
GPH (Liters) At Discharge Ft . Of Head
10 (3m)
6720 (25,438)
15 (4.6m) 20 (6.1m)
4200 (15,899) 1020 (3,861)
4
22 (6.7m)
0