VALBERG CNF 493 E X180C Consignes D'utilisation page 9

B
Using the appliance
1
6. Install cover (provide in the plastic bag) on the top right side. Then remove cover
from top left side of the appliance, and put it into the plastic bag.
1
3 2
7. Loose screw and take down part
4 and stop block-left 5 (provided in the plastic bag) to the left side with screw
1 2
part and part with the appliance for future reference.
1
2
3
4
5
8. Use the Allen wrench(provided in the plastic bag) and cross-shaped screwdriver to loosen
the screws and remove the middle hinge-right.
14
2
1
Screw hole cover-right
2
Screw hole cover-left
and part 1 , Install replacement door stopper-left
1 Door stopper
2
Stop block
3
Self-tapping screw
4 Door stopper-left
5
Stop block-left
EN
B
9. Change screw hole covers and screw on middle cover plate from left to right (as shown in
2
figure below).
10. Install middle hinge-left (in the plastic bag) . Transfer the upper door to the appropriate
position. Secure the door level, make the middle hinge axis into the lower hole of the upper
door. Install the hinge
3
. Keep
door by hand when installing.
11. Take out the connector from the hole on the top left side. Then connect it with the door
switch on the upper hinge cover-left.
Using the appliance
2 (provided in the plastic bag)by screws
1
1
2
2
Electrical
connector
15 EN
. Please hold the upper
1
Special flange screw
Upper hinge-left
Door
switch