VALBERG CNF 493 E X180C Consignes D'utilisation page 8

B
Using the appliance
1. Stand the refrigerator upright. Open the door to take out all door racks (to avoid damage)
and then close the door.
Fresh Zone
Please slightly squeeze the door rack from one
CAUTION:
side toward center, and then move it upward when taking
out the door racks.
2. Remove screw 1 , then take down cover
3
electrical connector below, because it's still connected. Then unconnect it and remove
2
cover .
1
2
3
4
12
press in wardly
2 from the top right side. Be careful of the
1
Self-tapping screw
2
Upper hinge cover
3
3
Electrical connector
4
Door switch
EN
B
Using the appliance
3. Press the door switch 4 , then remove it upward. Install switch
2
in the plastic bag). Put the other cover
5
4
4. Unscrew screws 1 by a 8mm socket driver or a spanner, and remove hinge
the conector 3 into the hole. Please hold the door by hand when installing.
1
2
3
5. Remove the upper door from the middle hinge by carefully lifting the door straight up.
Then Place the upper door on a smooth surface with its upper cover upwards.
13
5
4 into cover
into the plastic bag.
5 Upper hinge cover-left
2
. Then put
1
Special flange screw
2
Upper hinge
3
Electrical connector
Fresh Zone
EN
(provided