Cembre B131LN-C Notice D'utilisation Et Entretien page 6

ENGLISH
2.2) Die advancement
(Ref. to Figs. 1 and 5)
Press the operating button (17) located on top
of the pressure release button (16) to activate
the motor-pump and advance the lower
die.
To halt the advancement, release the operat-
ing button (17) and the motor will cut out.
Make sure the dies are exactly positioned on the desired crimp points, otherwise
reopen dies following instructions as per § 2.4 and reposition the connector.
2.3) Compression
– By keeping the operating button (17) pressed, the motor runs and the ram advances
until the two dies touch.
– It is recommended to continue pumping until the motor stops automatically.
2.4) Release of dies
By pressing the pressure release button (16) the ram (14) will retract and open the dies.
2.5) Head rotation
For ease of operation the tool head can rotate through 180°, allowing the operator to work
in the most comfortable position.
Warning: Do not attempt to turn the head when the hydraulic circuit is pressurised.
2.6) Die replacement
(Ref. to Fig. 2)
To replace dies proceed as follows:
– Upper die (91)
Take the die off its guide by pushing the die/head release pin (09).
Insert replacement die until secured by the die retaining pin (05).
– Lower die (90)
Take the die off its guide by pushing the die/ram release pin (12).
Insert replacement die until secured by the die/ram retaining pin (10).
To facilitate this operation an advancement of the ram (14) by 8-10 mm (0.3 - 0.4 in.) is
suggested.
17
16
5
FIG. 4
EXTERNAL SUPPLY
(only for B131LN-C and B131LN-CA)
ALIMENTATION EXTERIEURE
EXT. ENERGIEVERSORGUNG
ALIMENTACION EXTERNA
ALIMENTAZIONE ESTERNA
34
(soulement pour B131LN-C et B131LN-CA)
(Nur für B131LN-C und B131LN-CA)
(solamente para B131LN-C y B131LN-CA)
(solo per B131LN-C e B131LN-CA)