Operating External Components With The Remote Control; Operating The Tv - JVC TH-C60 Manuel D'instructions

Operating external components with the remote control

The buttons described below are used on pages 14 and 15.
Number
buttons
NOTE
• Manufacturers' codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.

Operating the TV

7 To set the manufacturer's code
1
Slide the remote control mode selector
to TV.
2
Press and hold F TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
Remote
control mode
selector
Manufacturer
JVC
Hitachi
Magnavox
Mitsubishi
Panasonic
Philips
RCA
* "01" is the initial setting.
5
(play button)
Release F TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7 Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
F TV:
TV VOL +/–:
TV/VIDEO:
CH +/–:
1-10, 0, h10 (100+): Selects the channel.
TV RETURN:
NOTE
• The operating buttons may differ depending on manufacturers.
Code Manufacturer
01* Samsung
10 Sanyo
02 Sharp
03 Sony
04, 11 Toshiba
15 Zenith
05
Turns TV on and off.
Adjusts the volume.
Selects the input mode (either TV or
VIDEO).
Changes the channels.
Alternates between the previously selected
channel and the current channel.
Code
12
13, 14
06
07
08
09
14