Horizon Global 76927 Instructions D'installation page 7

2b. Remove fascia - Using a flat head screwdriver, remove (4) plastic push-
pin rivet from outer bottom edge of fascia near wheel well, both sides.
2d. Remove fascia - Using a plastic trim tool, starting at the outer ends near
wheel well, carefully remove the fascia by gently pulling rearward while
releasing the clips holding the fascia.
©2022 Horizon Global Americas Inc. - Printed in Mexico
2c. Using a flat head screwdriver, from inside the rear wheel well, remove (1)
rivet. Note: The factory rivets cannot be reused. Four (4) replacement
rivets are supplied, (2) required, (2) spare.
2e. If equipped, disconnect all wiring harnesses from fascia and carefully
set fascia aside.
Sheet 7 of 30 76927NP 7/25/22 Rev. A