Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. Trim fascia –Locate the center of the fascia. Using a tape measure, marker, and utility knife, cut a notch in the bottom of fascia approximately 8.75'' wide by 4.25" tall.
See Figure 3. Note: Be sure area is clear of all electrical wiring before trimming.
9. Reinstall fascia/exhaust/taillights – Reconnect all wiring first. Then reinstall the fascia using original push-pin rivets removed in step 2. Next, using a plastic rivet gun,
install (1) rivet to hold fascia at the rear wheel well location removed in step 2. Then, reinstall exhaust, taillights, taillight covers using original fasteners and reconnect all
wiring removed in step 4.
©2022 Horizon Global Americas Inc. - Printed in Mexico
Sheet 10 of 30
76927NP
7/25/22
Rev. A
Publicité
Table des Matières
