Subaru H001SAN000 Instructions D'installation page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PRE-ARRANGED JUMPER HARNESS CONNECTION / RES ECU MOUNTING, continued
7
HARMAN/KARDON AUDIO SYSTEM EQUIPPED VEHICLES
11. Using two (2) of the supplied 39cm tie wraps, secure
the pre-arranged jumper harness to the vehicle's wire
harness above and below the pre-arranged harness
connection, as shown. Trim off the excess tie wraps.
(FIGURE T)
8
PANEL RE-ASSEMBLY
1. Re-install the passenger's side under dashboard fi nisher panel by engaging the three (3) pressure clips.
2. Re-install the glove box and strut.
3. At the end of the installation, insert the Quick Reference Cards into the Owner's Information Kit.
9
UNDER HOOD WARNING LABEL MOUNTING
1. Using alcohol, clean the top of the air intake plenum,
near the radiator core support.
NOTE: Ensure the air intake plenum is completely
dry.
2. Remove the release liner from the under hood
warning label and secure to the top of the air intake
plenum, as shown. (FIGURE U)
ISSUE
PART NUMBER
H001SAN000
DATE
00
12 Sept 2019
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE T
FIGURE U
SUBARU OF AMERICA
8 OF 12

Publicité

Table des Matières
loading

Table des Matières