Subaru H001SAN000 Instructions D'installation page 6

PRE-ARRANGED JUMPER HARNESS CONNECTION / RES ECU MOUNTING
7
HARMAN/KARDON AUDIO SYSTEM EQUIPPED VEHICLES
IMPORTANT! THIS SECTION ONLY APPLIES TO
VEHICLES WITH THE HARMAN/KARDON AUDIO
SYSTEM. FOR VEHICLES NOT EQUIPPED WITH THE
HARMAN/KARDON AUDIO SYSTEM, DISREGARD THIS
SECTION AND RETURN TO SECTION 6.
1. Locate the DC-DC Converter Module near the upper
left passenger's side glove box area and the remote
engine start ECU. Using a 10mm socket/ratchet,
remove the two (2) 10mm hex fl ange nuts securing the
DC-DC Converter Module and remove it from from its'
mounting location. Unplug the two (2) vehicle harness
connectors from the DC-DC Converter Module.
Using a Phillips screwdriver, remove the two (2) screws
securing the remote engine start ECU to the mounting
bracket, as shown. (FIGURE N)
NOTE: The remote engine start ECU mounting
bracket/screws will not be used on this vehicle.
2. Locate and release the vehicle's 12-pin pre-arranged
harness connector secured to the vehicle's wire
harness with breakaway tape near the upper left
passenger's side glove box area. (FIGURE O)
3. When the vehicle's 12-pin pre-arranged harness
connector is free from the breakaway tape, route the
harness down through the opening in the glove box
inner cover. Plug the 12-pin pre-arranged harness
connector into the remote engine start jumper harness
12-pin connector. (FIGURE P)
ISSUE
PART NUMBER
H001SAN000
DATE
00
12 Sept 2019
DC-DC Converter
Module
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE N
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE O
FIGURE P
SUBARU OF AMERICA
Hidden From View
Remote Engine
Start ECU
6 OF 12