Subaru H001SAN000 Instructions D'installation page 4

PRE-ARRANGED JUMPER HARNESS CONNECTION / RES ECU MOUNTING
6
NON HARMAN/KARDON AUDIO SYSTEM EQUIPPED VEHICLES
IMPORTANT! THIS SECTION ONLY APPLIES TO
VEHICLES WITHOUT THE HARMAN/KARDON AUDIO
SYSTEM. FOR VEHICLES EQUIPPED WITH THE
HARMAN/KARDON AUDIO SYSTEM, DISREGARD THIS
SECTION AND PROCEED TO SECTION 7.
1. Locate and release the vehicle's 12-pin pre-arranged
harness connector secured to the vehicle's wire
harness with breakaway tape near the upper left
passenger's side glove box area. (FIGURE H)
2. When the vehicle's 12-pin pre-arranged harness
connector is free from the breakaway tape, route the
harness down through the opening in the glove box
inner cover. Plug the 12-pin pre-arranged harness
connector into the remote engine start jumper harness
12-pin connector. (FIGURE I)
3. Route the remote engine start harness back through
and behind the glove box inner cover. Plug the remote
engine start jumper harness 12-pin connector into the
12-pin white port on the remote engine start ECU.
(FIGURE J)
ISSUE
PART NUMBER
H001SAN000
DATE
00
12 Sept 2019
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE H
FIGURE I
FIGURE J
SUBARU OF AMERICA
4 OF 12