PRE-ARRANGED JUMPER HARNESS CONNECTION / RES ECU MOUNTING, continued
7
HARMAN/KARDON AUDIO SYSTEM EQUIPPED VEHICLES
4. Route the remote engine start harness back through
and behind the glove box inner cover. Plug the remote
engine start jumper harness 12-pin connector into the
12-pin white port on the remote engine start ECU.
(FIGURE Q)
5. Using alcohol, clean the face of the DC-DC Converter
Module above and below the ID label and the back of
the remote engine start ECU, as shown. (FIGURE Q)
NOTE: Ensure the DC-DC Converter Module and
Remote Engine Start ECU are completely dry.
6. Using the supplied double sided foam tape, remove
the two (2) release liners and attach to the face of the
DC-DC Converter Module above and below the ID
label, as shown. Press the foam tape fi rmly in place
for at least thirty (30) seconds. (FIGURE R)
NOTE: Ensure the foam tape does not cover the
DC-DC Converter Module ID Label.
7. Remove the two (2) remaining release liners from the
foam tape and attach the remote engine start ECU, as
shown. Ensure the ECU is mounted fl ush with the top,
left edges of the DC-DC Converter Module without
interferring with the two (2) bracket mounting holes.
Press the ECU fi rmly in place for at least thirty (30)
seconds. (FIGURE S)
8. Using one (1) of the supplied 39cm tie wraps, secure
the remote engine start ECU to the DC-DC Converter
Module, as shown. Trim off the excess tie wrap.
Plug the two (2) vehicle harness connectors back into
the DC-DC Converter Module. (FIGURE S)
9. Using the two (2) previously removed 10mm hex fl ange
nuts, secure the DC-DC Converter Module and remote
engine start ECU assembly back to the factory bracket/
studs. (FIGURE S)
10. Using a 10mm socket/torque wrench, tighten the 10mm
hex fl ange nuts to 7.5 Nm +/- 2 Nm (0.76 Kgf-m +/- 0.2
Kgf-m, 5.5 ft-lbs +/- 1.5 ft-lbs).
PART NUMBER
ISSUE
H001SAN000
DATE
00
12 Sept 2019
Clean with
Alcohol
FIGURE Q
FIGURE R
T
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE S
SUBARU OF AMERICA
Clean with
Alcohol
ID Label
Remote Engine
Start ECU
ID Label
T
Hidden From View
7 OF 12