Subaru H001SAN000 Instructions D'installation page 5

PRE-ARRANGED JUMPER HARNESS CONNECTION / RES ECU MOUNTING, continued
6
NON HARMAN/KARDON AUDIO SYSTEM EQUIPPED VEHICLES
4. Locate the factory mounting bracket/studs near the
upper left passenger's side glove box area.
(FIGURE K)
5. Using the two (2) supplied 10mm hex fl ange nuts,
secure the remote engine start ECU/bracket to the
factory bracket/studs, as shown. (FIGURE L)
6. Using a 10mm socket/torque wrench, tighten the 10mm
hex fl ange nuts to 7.5 Nm +/- 2 Nm (0.76 Kgf-m +/- 0.2
Kgf-m, 5.5 ft-lbs +/- 1.5 ft-lbs).
NOTE: Ensure the Remote Engine Start ECU
connectors will be facing forward, toward the
vehicle's dashwall.
7. Using two (2) of the supplied 39cm tie wraps, secure
the pre-arranged jumper harness to the vehicle's wire
harness above and below the pre-arranged harness
connection, as shown. Trim off the excess tie wraps.
(FIGURE M)
PART NUMBER ISSUE
H001SAN000
DATE
00 12 Sept 2019
Factory
Mounting
Bracket
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE K
T
T
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE L
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE M
SUBARU OF AMERICA
5 OF 12