EN
· Any automatic start of the machine without press-
ing the gun trigger is attributable to air bubbles in
the water or other similar phenomena which do not
imply the existence of any defects in the machine.
· Do not leave the appliance unattended during the
standby for more than 5 minutes. Contrarily, for the
safety of the appliance it is necessary to re-turn the
switch into the (0) OFF position.
· Please check that the coupling of the high pressure
hose with the appliance and the gun supplied as
standard equipments made correctly, that is to say
without any water leak.
> SWITCHING OFF
See fig.
turn the switch pos. 2 (0) OFF position and wait that
the water get completly cold.
In this way you avoid any calcareous deposit and
overheatings of the coil and the boiler, which are al-
ways dangerous.
IMPORTANT: When the machine is switched off,
always discharge the pressure hose, opening the
gun.
CARE AND MAINTENANCE
See fig.
•
X X WARNING: the machine shall be discon-
nected from its power source, by removing
the plug from the socket-outlet, during
cleaning or maintenance
• WARNING: Do not spray the appliance with
water and do not use detergents or aggres-
sive solvents. Machine could be damaged.
·
Clean the exterior part of the machine with a dry
cloth.
- Always keep the machine clean so that the cooling
air can pass through the slits without obstructions..
- Cleaning the water filter: To ensure the pump gives
good service it is extremely important to check and
clean the water filter frequently. Use pliers to extract
it from the pump and rinse it carefully in running wa-
ter.
- Cleaning the nozzle: A blockage in the nozzle may
prevent the machine from operating correctly, so it
must be kept clean. Switch off the machine and re-
move the lance. Clean the nozzle with the pin pro-
vided. Rinse the lance in running water.
- When topping up the oil in the pump, use a SAE
20W40 mineral oil. Quantity supplied: 70 gr.
- The replacement of the fuel metal pipe is requested
after disassembling to avoid fuel leakages.
20
- 5
> STORAGE
See fig.
· Move the machine only by grasping the car-
rying handle
· Store the appliance and the accessories in a
frost-safe room.
WARRANTY CONDITIONS
All our machines are subjected to strict tests
and are covered against manufacturing de-
fects in accordance with applicable regula-
tions. The warranty is effective from the date of
purchase. The following are not included in
the warranty: - Parts subject to normal wear.
- Rubber parts, charcoal, filters and the acces-
sories and optional accessories. - Accidental
damage, caused by transport, neglect or inad-
equate treatment, incorrect or improper use
and installation failing - The warranty shall not
cover any cleaning operations to which the op-
erative components may be subjected, such
as clogged nozzles and filter blocked due to
limestones. This pressure cleaner is intended
to be used for domestic and hobby work: the
warranty does not cover any other different
kind of use.
DISPOSAL (WEEE)
As the owner of electrical or electronic
equipment, the law (in accordance with the
EU Directive 2012/19/EU on waste from electrical
and electronic equipment and the national laws of
the EU Member States that have implemented this
Directive) prohibits you from disposing of this prod-
uct or its electrical / electronic accessories as munici-
pal solid waste and obliges you to make use of the
appropriate waste collection facilities.The product
can be disposed of by returning it to the distributor
when a new product is purchased. The new product
must be equivalent to that being disposed of. Dis-
posing of the product in the environment can cause
great harm to the environment itself and human
health. The symbol in the figure indicates the ur-
ban waste containers and it is strictly prohibited to
dispose of the equipment in these containers. Non-
compliance with the regulations stipulated in the
Directive 2012/19/EU and the decrees implemented
in the various EU Member States is administratively
punishable.