Setting Down And Storing The Vacuum Cleaner; Maintenance - Miele Classic C1 SB 1 Série Mode D'emploi

To open the air inlet valve (dia. 14)
It is easy to reduce the suction power
for a short time, e.g. to prevent rugs or
other objects being sucked into the
vacuum cleaner.
 Open the air inlet valve on the handle
far enough to reduce the suction
power.
The floorhead will be easier to manoeu‐
vre. Close the valve when you are ready
to use full power again.
Setting down and storing the
vacuum cleaner
Park system for pauses during vac‐
uuming (dia. 15)
The Park system allows you to conven‐
iently park the suction tube and floor‐
head during pauses.
 Slot the floorhead into the parking at‐
tachment at the back of the vacuum
cleaner.
If your vacuum cleaner is on a slop‐
ing surface, e.g. a ramp,
- retract the telescopic tube fully
- do not use the park system if your
vacuum cleaner has an EasyLock
suction tube.
Park system for storage (dia. 16 + 17)

Always disconnect the vacuum
cleaner from the electrical supply
when you have finished using it.
Switch it off at the wall socket and
unplug it.
 Stand the vacuum cleaner upright.
If your vacuum cleaner has a tele‐
scopic tube, retract the tubes fully so
that it takes up less room for storage.
 Slot the floorhead downwards into
the parking attachment on the side of
the vacuum cleaner.
If your vacuum cleaner has an Easy‐
Lock suction tube you can separate the
two sections for storage purposes.
 Press the release button on the lower
section and pull the top section out.
 Push the connection piece attached
to the upper tube into the lower tube.

Maintenance


Always disconnect the vacuum
cleaner from the electrical supply for
maintenance work and for cleaning.
Switch off at the wall socket and un‐
plug it.
The Miele filtration system consists of
three components:
– Dustbag
– Dust compartment filter (for motor
protection)
– Exhaust filter
These will need to be replaced from
time to time to ensure that your vacuum
cleaner performs efficiently.
en
33