Setting Down And Storing The Vacuum Cleaner; Maintenance - Miele SBAN0 Mode D'emploi

en-US
The vacuum cleaner has symbols on
the controls which indicate the type of
use the settings are suitable for.
 Curtains, fabric
 Upholstery, cushions
 Deep pile carpets, rugs and run-
ners
 Energy-saving vacuuming. This
setting is also very quiet
 Low pile carpet and rugs
 Hard flooring and heavily soiled
carpets and rugs
 Turn the suction power selector man-
ually to the suction power setting you
require.
Opening the air inlet valve (Fig. 20)
It is easy to reduce the suction power
for a short time, e.g., to prevent rugs or
other objects being sucked into the
vacuum cleaner.
 Open the air inlet valve on the handle
far enough to reduce the suction
power.
This reduces the suction on the respec-
tive nozzle used.
Setting down and storing the
vacuum cleaner
Park system for pauses during vacu-
uming (Fig. 21)
The Park system allows you to conve-
niently park the suction wand and floor-
head during pauses.
 Slot the floorhead into the parking at-
tachment on the vacuum cleaner.
16
If your vacuum cleaner is on a slop-
ing surface, e.g. a ramp,
- retract the telescopic suction wand
fully
- do not use the park system if your
vacuum cleaner has an EasyLock
suction wand.
Park system for storage
(Figs. 22 + 23)

Always disconnect the vacuum
cleaner from the power supply when
you have finished using it. Remove
the plug from the socket.
 Stand the vacuum cleaner upright.
If your vacuum cleaner has a tele-
scopic suction wand, retract the wand
fully so that it takes up less room for
storage.
 Slot the floorhead downwards into
the parking attachment.
If your vacuum cleaner has an Easy-
Lock suction wand you can separate
the two sections for storage purposes.
 Press the release button on the lower
section and pull the top section out.
 Push the connection piece attached
to the upper wand section into the
lower section.

Maintenance


Always switch off the vacuum
cleaner for maintenance work and
remove the plug from the outlet.
The Miele filtration system consists of
three components: