Miele Classic C1 SB 1 Série Mode D'emploi page 32

en
Standard adjustable floorhead
(dia. 09)
For general use and also for vacuuming
the stairs.

For safety reasons when vac‐
uuming stairs it is best to start at the
bottom of the stairs and move up‐
wards.
Use
To unwind the mains cable
(dia. 10)
 Pull the mains cable out to the re‐
quired length (max. cable length ap‐
prox. 5.5 m).

If vacuuming for longer than 30
minutes, the mains cable must be
pulled out to its fullest extent. Other‐
wise there is a danger of overheating
and damage.
To rewind the cable
 Switch off at the wall socket and re‐
move the plug.
 Press the rewind foot switch. The
cable will rewind automatically.
To switch on and off (dia. 11)
 Press the On/Off foot control .
32
During vacuuming

When vacuuming fine dust, e.g.
sawdust, sand, plaster, flour, talcum
powder etc., electrostatic charges
build up naturally. Under certain con‐
ditions these charges will be re‐
leased. To avoid the unpleasant ef‐
fects of these discharges, a metal in‐
lay has been incorporated into the
underside of the handle. Please
make sure that you keep your hand
in constant contact with this metal
strip during vacuuming (dia. 12).
To regulate the suction power
(dia. 13)
The suction power can be regulated to
suit the type of flooring being cleaned.
Reducing the suction power reduces
the amount of effort required to ma‐
noeuvre the floorhead.
The vacuum cleaner has symbols on
the controls which indicate the type of
use the settings are suitable for.
 Curtains, fabric
 Upholstery, cushions
 Deep pile carpets, rugs and run‐
ners
 Energy-saving vacuuming. This
setting is also very quiet
 Loop pile carpet and rugs
 Hard flooring and heavily soiled
carpets and rugs
 Turn the suction power selector ma‐
nually to the suction power setting
you require.