Wall Control; Installation Of The Wall Control - Broan-NuTone AE60 Guide D'installation Et D'utilisation

4.

WALL CONTROL

4.1 I
NSTALLATION OF THE
Always disconnect the unit before making any connections. Failure in
disconnecting power could result in electrical shock or damage of the
wall control or electronic module of the unit.
Never install more than one optional wall control per unit.
1. Determine the more convenient location for the control.
2. Remove the cover plate control (1). If you prefer to mount
the wall control on an approved outlet box or an approved
mounting bracket (not included), discard the backplate (2).
To avoid risk of electrical shocks, never install another wire in the same
electrical box than the one for the wall control.
3. Take one end of the cable and pass it through the wall control backplate (or outlet box
or mounting bracket).
4. Splice back this end of the cable to access to the 4 wires. Remove the insulated
sleeve of each wire ends. Make a loop with each bare end wire to hook them to their
corresponding screw. Connect YELLOW wire to "Y" screw, RED wire to "R" screw,
GREEN to "G" screw and BLACK to "B" screw. See illustration below.
Make sure that the wires don't short circuit between themselves or by
touching any other components on the wall control.
W
ALL
! WARNING
CAUTION
WARNING
!
BLACK
wire
GREEN
wire
! WARNING
C
ONTROL
YELLOW
RED
wire
18
2
wire
1