Exterior Opening(S) Installation - Broan-NuTone AE60 Guide D'installation Et D'utilisation

3. INSTALL THE UNIT
3.7 E
XTERIOR
3.7.1 T
ANDEM
1. For each duct, pull back the insulation to expose the interior flexible duct.
Always connect the exhaust air to outside duct on top section of the
Tandem transition.
2. Connect the interior flexible duct to the smaller part of the Tandem transition (5'' oval)
using a tie wrap.
3. Pull the insulation over the joint. Pull the vapor barrier over the insulation.
4. Apply duct tape gently to the joint in order to make an airtight seal. See figures below.
1
VJ0025
3
VJ0023
Dual exterior hood requires assembly. Using 2 no. 8 x 3/4" screws, assemble the top metal
screen and the plastic grille to the dual exterior hood. Then, slide the bottom metal screen to
the dual exterior hood. See illustration below.
O (
PENING S
T
RANSITION WITH
VO0024
(CONT'D)
) I
NSTALLATION
D E
UAL XTERIOR
CAUTION
2
E
OUTSIDE DUCT ON
VJ0022
4
VJ0024
12
( ' )
CONT D
H
( ' )
OOD
CONT D
XHAUST AIR TO
TOP SECTION