Elvox EI30 Mode D'emploi page 8

GB
TYPICAL CONNECTION AND CABLE SECTION
Art. ECA8
4X0,75mm
3X1,5mm
Linea 230V
Line
INSTALLATION
Introductory note: Dig a hole big enough to hold the operator, calculate the required opening angle considering that the EI30 operator can also be
installed Out of Axis, insert the sheath for laying the power cable, and cement solidly.
GATE WING OPENING ANGLE
Establish the required opening angle opportunely positioning the opening locks for the shutters.
Installation of mechanical limit stops.
At the open and closed positions of the sliding gate, it is recommended that mechanical limit stops are fitted which are able to stop the movement
of the gate during both opening and closing. Always follow the recommendations of the various relevant standards.
In the case of gates longer than 1.6 m the use of an elbow-bolt, type ZD06 (Fig. 3) or ZD26, with electric door lock Art. ZD04 (Fig. 3A) is recommended.
Positioning the gate:
Place the gate in a vertical position making sure that the pin of the gearmotor is properly positioned in the dowel welded to the support bracket and
that the pin is directly in line with the upper hinge of the gate.
VERY IMPORTANT:
Drain pipe must be perfectly clean inside to ensure the rapid discharge of rain water. Cover the entire pipe length with gravel to facilitate water
drainage and prevent earth from entering and clogging the drain pipe.
Fig.3
4X1,5mm (230 Vca )
Fotocellula RX
Photocell Rx
2
Art. EFA1
2
2
EI30
2
2
2X0,75mm
Fotocellula TX
Photocell Tx
2X0,75mm
Art. EDS1
Fig.3A
8/28
Art. EFA1
2
Art. ELA1/L