SSS Siedle SET VAB 850-1 Information Produit page 12

Programming – manual
Programming door calls
Application
Call from the door station to an
indoor device.
1 Activate the programming mode
on the SNG 850-... Briefly press the
programming mode button, LED 1
flashes every 2 seconds.
3b Bus video panel
Tap Settings; > Installation; > Start
Programming; > Start. The bus video
panel establishes the speech con-
nection to the door station. The bus
video panel is now in the program-
ming mode.
12
The call tone volume can be set on
the indoor device see operating
instructions.
2 At the door station, hold down
the light/programming button for
4 seconds. A protracted acknow-
ledgement tone is then audible
which is repeated every 5 seconds
as long as the programming mode
remains active.
4 On the door station, press and
hold the desired call button for
4 seconds until a sustained tone can
be heard from the door loudspeaker.
The call button is now assigned to
the bus indoor device.
3a Siedle Basic
Hold down the speech button for
4 seconds. A protracted acknow-
ledgement tone sounds as confirma-
tion and the muting LED begins to
flash. The bus indoor device estab-
lishes the speech connection to the
door station. The bus indoor device
is now in the programming mode.
4 Sek.
5 The call button is now firmly assi-
gned to the bus indoor devices.
Program additional users using the
same procedure or quit the pro-
gramming mode.