Russell Hobbs RHI101 Mode D'emploi page 6

6. The appliance is now ready for use.
7. Move the Variable Steam Control to give the desired amount of steam.
8. Turn the Temperature Dial in an anti-clockwise direction to "Min", and then the iron
will switch off.
9. Disconnect the iron from the mains supply outlet.
10. When the appliance cools down completely, store it in a safe place.
11. Do not wrap the cord around the iron.
BURST OF STEAM
This function provides an extra amount of steam to remove
stubborn wrinkles.
1. Fill the water tank as described in "How to Fill Water"
2. Connect the appliance to a suitable mains supply outlet.
3. Turn the Temperature Dial to '
'Max' setting. The Pilot light glows, indicating the iron is
switched on.
4. The Pilot light goes off when the required temperature is
reached.
5. The appliance is now ready for use.
6. Press the Burst of steam button once.
7. Steam will shoot from the holes of the soleplate into the fabric being ironed
and remove wrinkles.
8. For stubborn wrinkles, wait a few seconds before pressing the burst of steam
button again. Most wrinkles can be removed within three presses.
9. Turn the Temperature Dial in an anti-clockwise direction to "Min", and then the
iron will switch off.
10. Disconnect the iron from mains supply outlet.
11. When the appliance cools down completely, store it in a safe place.
12. Do not wrap the cord around the iron.
Note: It may be necessary to press the burst of steam button a few times to start this
function. For optimum steam quality, do not operate the Burst of Steam more than
three times after the pilot light goes off.
BURST OF STEAM IN VERTICAL POSITION
Warning:
Do not apply steam on any clothes or fabrics that are being worn by humans or pets.
The Temperature of the steam is very hot.
This function provides steam to remove wrinkles on delicate
garments in a hanging position, hanging curtains or other hanging
fabric.
1. Fill the water tank as described in "How to Fill Water"
2. Connect the iron to a suitable mains supply outlet.
3. Turn the Temperature Dial to '
setting. The Pilot light glows indicating the iron is switched on.
4. The Pilot light goes off when the required temperature is
reached. The appliance is ready for use.
5. Hold the iron between 15 and 30 centimeters away from the garment.
' (3 dots) setting or to
' (3 dots) setting or to 'Max'