Code Identification - RCA RCU807 Mode D'emploi

RCU807US_IB_REVB 9/26/03
To search for a specific code in one of the Code Lists, follow these steps:
1. Manually turn on the component to be controlled
(TV, VCR, DVD, etc.).
2. Press and hold the SETUP (S) key for 2-3 seconds until
the LCD display shows the Setup Mode? Screen.
3. Release the SETUP (S) key.
4. Press and release the desired component key (TV, VCR,
SAT•CBL, etc.). For AUX1 or AUX2, press and release the
AUX1 or AUX2 key followed by the desired component
key to be programmed under that key.
If the AUX1 or AUX2 key is selected, the status display
Note:
will alternate between showing the AUX number (AUX1 or
AUX2) and the component label (TV, VCR, SAT•CBL, etc.)
at 0.5-second intervals.
5. The LCD shows the Code Search Screen, which displays
the component mode and its current programmed code.
Press and release the CH+ or ON•OFF key repeatedly until
the component to be controlled responds to the command.
Press and release the ENTER key to save the code. After
you install this code, any previously Learned commands
will be deleted.
The Code Search starts from the currently stored code
Note:
under that mode. For example, if the component Code List
contains 100 codes and the currently stored code is 050,
the Code Search starts from 051 and continues to 100 before
looping back to 000 and finishing at 050. This speeds up
the process of finding the correct code for your component,
since you may discover that some codes can turn your
component on and off but are not able to control its other
functions. This process allows you to bypass codes you've
already tried. The display will show the End Screen once
all code list entries have been searched.
6. If your component responds and you accidentally overshoot
that code by pressing the CH+ or ON•OFF key again, press
and release the CH- key to backtrack through the Code List.
You can change the direction to forward once again by
pressing the CH+ or ON•OFF keys.
7. After pressing the ENTER key in step five, the LCD
displays the Success Screen, then returns to the normal time
display. The Code Search Entry method is now complete.

Code Identification

Code Identification allows you to find out what code is currently
programmed in the remote under a given mode (TV, VCR, DVD, etc.).
To find the currently programmed code, follow these steps:
1. During normal remote operation, press and hold any
component key. The top right corner of the LCD display
shows the current code programmed for that component.
2. Release the component key to return the display to normal.
10:18 Page 7
7