Troubleshooting - RCA RCU807 Mode D'emploi

RCU807US_IB_REVB 9/26/03

Troubleshooting

PROBLEM
The LCD status display is
blank when you press a key.
The remote does not operate
your audio or video components.
You have problems programming a TV/VCR,
TV/DVD, or VCR/DVD combination unit.
Your VCR is not recording.
You have trouble changing the channels
on your TV.
The SELECT/OK key is not responding.
The IR Learning or SmartMacro processes
cannot be completed successfully.
18
10:18 Page 18
SOLUTION
• Check to make sure the
batteries are properly installed.
• Replace the batteries with
four new AAA alkaline batteries.
Try all code programming procedures
•
with all the codes from the appropriate
part of the Code Lists.
Make sure the remote is in the correct mode
•
for the component you are attempting to
control (TV, VCR, DVD, etc.)
Make sure the remote is pointed
•
at the component being operated.
Try the VCR or DVD code for your brand.
•
Some combination units, however, may
require both a TV and a VCR and/or DVD
code for full operation depending on your
unit. To do this, program the TV code under
the TV key and the VCR and/or DVD under
the VCR and/or DVD key.
As a safety feature on your remote,
•
you must press the RECORD key twice.
If your original remote requires the ENTER
•
key to be pressed after a channel is selected,
press the ENTER key on the RCU807 to
select the channel.
Try using the MENU, GUIDE or ENTER
•
key to make the selection.
Replace batteries in the RCU807 and the
•
remote from which you are trying to learn.
The distance between the remotes
•
should be approximately 2-3 inches.
Do not conduct the Learning process
•
near an incandescent lamp.
The memory capacity is full (six Learned
•
commands for each of the three Macros).
The original remote may not be
•
compatible with the Learning procedure.