Code Entry; Code List Entry; Code Search - RCA RCU807 Mode D'emploi

RCU807US_IB_REVB 9/26/03

Code Entry

In order for the RCU807 to control your components (TV, VCR, DVD, etc.), you must program it
with the corresponding code from the Code Lists. (Refer to the Code List enclosed.) This enables
the remote to control your component with the proper commands. If your TV, VCR, DVD or satellite
receiver is an RCA, PROSCAN or GE brand, the RCU807 may not need any programming to control
it. To program the remote with the codes for your components, you can use one of three methods:
Code List Entry, Code Search or Code Autosearch.

Code List Entry

You can enter codes in your RCU807 from the Code Lists using the SETUP (S) key. When you
enter a valid code for any given mode (e.g., when you enter a valid code for a TV), any previously
Learned functions for that mode are deleted.
To enter a code directly from one of the Code Lists, follow these steps:
1. Manually turn on the component to be controlled
(TV, VCR, DVD, etc.).
2. Press and hold the SETUP (S) key for 2-3 seconds
until the LCD display shows the Setup Mode? Screen.
3. Release the SETUP (S) key.
4. Press and release the desired component key
(TV, VCR, SAT•CBL, etc.). For AUX1 or AUX2, press
and release the AUX1 or AUX2 key followed by the desired
component key to be programmed under that key.
If the AUX1 or AUX2 key is selected, the status
Note:
display will alternate between showing the AUX number
(AUX1 or AUX2) and the component label (TV, VCR,
SAT•CBL, etc.) at 0.5-second intervals.
5. Enter the three-digit code for your component brand from
the corresponding Code Lists at the back of this User's Guide.
If your brand has more than one code listed, begin with the
first code. When a valid code from the list is entered, the
LCD displays the Success Screen, then returns to the normal
time display.
For an invalid code entry, the LCD displays the Invalid
Note:
Screen for three seconds before returning to the normal time
display. In this case, no changes are made.
6. With the component on, aim the RCU807 at the component
and press and release the ON•OFF key. If you have entered
the correct code number for your component, it responds
to the ON•OFF key. If the component responds, no further
programming is required. Code List Entry is now complete.
7. If your component does not respond, try the next code in the
list for your brand by repeating the procedure starting at step
two. If no other codes exist for your brand, try the Code Search
or Code Autosearch methods.

Code Search

If the component you wish to control does not respond to any of the codes you have entered
using the Code List Entry method, you can search the entire Code List for a particular component
that might not be listed in the Code List or might be listed under a different brand.
When you enter a valid code for any given mode (e.g., when you enter a code for a TV),
any previously Learned functions for that mode are deleted.
6
10:18 Page 6