Function Description - MetaSystem Meta EasyCan EVO Digital Instructions De Montage

CUSTOMISING THE OPERATING MODES
The available operating modes are listed in the following table. The factory settings are in bold type and the
possible alternatives are in plain text.
To change the factory programming, going from line "A" to line "B" of the table (or vice versa) proceed as follows:
NOTE: Passage, via +15 panel, from line "A" to line "B" is indicated by 1 Boop and by 1 Beep from line "B" to line "A".
Going from one selection to the next using the push button is indicated by the arrows fl ashing. The functions that
are not available are shown by the very fast fl ashing of the LED.
MAX.
5 SEC.
MAX.
5 SEC.
ACCESS
TO THE
OPERATING
MODE
TABLEE
1 BEEP
RE-CHECK/
REPROGRAMMING
X 3 SEC.
When programming is fi nished the selections made can be checked again and even changed if wanted by
returning to function no. 1. To go from function no. 11 to no. 1, press the key for 3 seconds; 1 BEEP signals return
to function no. 1.
The selectable functions, 1 and 9 contrast with the European Directive 95/56/EC.
(This means that activation is not allowed in all community member states).
ARM./DISARM.
1
YES
HORN
2
CONTINUOUS
DELAYED
3
CURRENT
DROP
YES
SENS.
4
HIGH
BLINKER ARM./
DISARM.
5
YES
PASSIVE ARMING
6
YES
PASSIVE
ARMING
7
+ ALARM
YES
DOOR
PROTECTION
8
DERIVED
ANTI-CARJACK
9
ALARM
YES
BLINKER
10
CONTROL OF
11
BLINKER
CONTINUOUS
SWITCH

FUNCTION DESCRIPTION

1
NO
It allows to control a horn or pager relay
2
ALTERNATING
with a continuous or alternating command.
It renders operative the protection for
3
NO
It allows to vary the sensitivity of the
4
STANDARD
5
NO
It automatically activates the engine
6
NO
It automatically activates the engine
7 block protection and the alarm part,
NO
It determines whether or not just the one
8
CONTINUOUS
9
unauthorised use, triggering an alarm cycle and making
NO
10 controlled by means of power on the lamps
or on the push button of the car blinkers.
It determines whether the Blinker push
11
SINGLE
IMPULSE
continuous signal or with a single pulse.
2 BEEP EXIT
2 BOOP
20
Buzzer rings during activation
and deactivation of the alarm.
current absorption on the vehicle
volumetric protection.
Blinker working during activation
and deactivation of the alarm.
block protection.
disabling the ultrasounds
alarm cycle is executed with a Doors,
Boot and Bonnet alarm stimulation.
If it is ON it protects the vehicle in the case of
it impossible for the engine to be started again.
It determines whether the Blinker is
button is controlled by means of a
.
.