MetaSystem Meta EasyCan EVO Digital Instructions De Montage page 16

To control the blinkers during an alarm phase it is essential to connect the BLUE and BLUE/GREEN wires.
The product allows the blinkers to work either with the positive signals connected directly to the lamps (Fig. 12)
or controlling the negative signal directed to the car's Blinker button (Fig. 13). Like the OEM alarms also the Meta
EasyCan EVO Digital unit has a feature of extending fl ashing of indicators for 25 sec. following the acoustic; to
exclude this feature you have to deactivate the selection nr°31 with the PRG007 programmer. If the car doesn't has
the original fl ashes of the indicators during locking and unlocking the doors it's necessary set ON both selections
nr°5 and nr°30 using programmer PRG007.
LIGHT BLUE/GREEN
Fig. 12
Use the existing push button only if they close to earth.
DOORS
M134 DIODE
MODULE OR
1N4002 (X4)
ORIGINAL
DOOR
SWITCHES
Fig. 14
An attempt to start the car with the control unit activated will activate the internal relay and open the ignition
block circuit.
PETROL PUMP
ELECTRONIC
INJECTION
Fig. 17a
LIGHT BLUE
PROTECTION OF THE PERIPHERALS
ENGINE BONNET
MOUNT
BOOT
GREEN
PROTECTION
SWITCH
Fig. 15
IGNITION BLOCK
BLINKER
Fig. 13
PURPLE
STARTER
MOTOR
Fig. 17b
16
CONTROL
LIGHT BLUE/GREEN
FEEDBACK
LIGHT BLUE
BOOT
COURT LIGHT
IN BOOT
PURPLE
+
ORIGINAL
BOOT
SWITCHES
Fig. 16
MOUNT AN
ADDITIONAL
30A RELAY
WHITE
DARK BLUE