R&G LP0224 Mode D'emploi page 6

•
Remove the four bolts arrowed in picture 3.
•
Carefully lower the original licence plate bracket as shown in picture 4.
•
Disconnect the three wiring plug sockets for the licence plate illuminator and indicators as
arrowed in picture 5 (you will have to cut the several cable ties).
•
Remove the four metal spacers as shown in picture 6.
•
Remove the four rubber mounting bushes as shown in picture 7.
Page | 6
•
Fit the four rubber mounting bushes to the new licence plate bracket (item 1) as shown in
picture 8.
•
Fit the four metal spacers into the four rubber mounting bushes already fitted to the new
licence plate bracket (item 1) as shown in picture 9.
•
Fit the four new mounting spacers (item 4) over the original metal spacers as shown in
picture 10 (a small amount of adhesive may be used to keep these spacers in position).
•
Cut the rubber edging strip into suitable lengths and stick in position to the cover (item 5)
and the new licence plate bracket (item 1) as arrowed in pictures 11, 12 and 13.
•
Fit the new licence plate illuminator (item 8) to the new licence plate bracket (item 1) as
shown in pictures 14 and 15 (please use the provided heat shrink (item11) to protect the
wiring).
•
PLEASE NOTE YOU WILL NEED TO GLUE THE LIGHT SHROUD TO THE
LED LICENCE PLATE ILLUMINATOR USING SUPER GLUE.
•
When fitting the R&G licence plate illuminator (item 8), the OEM wiring will need to be
"cut and shut" in order to re-use the connectors to connect to the wiring loom. This is
done by cutting the connector off the OEM licence plate illuminator, before fitting the
remaining bullet connectors (item 14 – CON0004) to the exposed wiring and connecting
to the R&G light. Plug it into the loom to check at this stage (if illumination fails, swap
the bullet connections around). (Please use the heat-shrink (item 11) to protect the new
indicator wires).
If reusing the original indicators
•
Cut the cable ties securing the wiring and remove the indicator (please note witch side it
came off).
•
Repeat the above to remove the other indicator (please note the relevant sides).
•
Gently squeeze the indicator stem and push through the shape aperture in the new licence
plate bracket (item 1) as shown in picture 16 (a small amount of silicon grease or liquid
detergent helps in this process
•
Fit the indicators to the new licence plate bracket (item 1) as they were mounted
originally (ensure they are fitted on the correct sides).
If fitting the R&G mini indicators (R&G product code RG370=bulb, RG371=LED or RG372 for Aero LED
•
If fitting the R&G Mini Indicators, the OEM indicator wiring will need to be "cut and
shut" in order to re-use the connectors to connect the R&G Mini Indicators to the wiring
loom. This is done by cutting the connectors off the OEM indicators, before fitting the
bullet connectors (item 15 – CON0004) to the exposed wiring and connecting to the R&G
indicators. Plug it into the loom to check at this stage (if illumination fails, swap the bullet
connections around).
•
Use the remaining CON004 (item 9), to connect to the main harness. (If illumination fails,
swap the bullet connections around). It is a good idea at this point to turn the ignition on
and check for the correct operation of all lights.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com Email:
6
LP0224
info@rg-racing.com