Andis AGC2 Instructions D'utilisation Et D'entretien page 3

5. Never operate this appliance if it has a damaged cord or
plug, if it is not working properly, if it has been dropped or
damaged, or dropped into water. Return the appliance to
an Andis authorized service station for examination and
repair.
6. Keep the cord away from heated surfaces.
7. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
8. Never drop or insert any object into any opening.
9. Do not use outdoors or operate where aerosol (spray)
products are being used or where oxygen is being
administered.
10. Do not use this appliance with a damaged or broken blade
or comb, as injury to the skin may occur.
11. To disconnect turn control to "off" then remove plug from
outlet.
12. WARNING: During use, do not place or leave appliance
where it may be (1) damaged by an animal or (2) exposed
to the weather.
13. This appliance is intended for trimming purposes only.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR HOUSEHOLD USE
OPERATING INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a polarized plug (one
blade is wider than the other). This plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper outlet. Do not
change the plug in any way.
Plug cord into electrical outlet, operate 120 volt, 60 cycle AC electrical
current or as noted on unit.
2-SPEED OPERATION
Your Andis clipper comes with normal and high speed operation (Diagram
A). Use the normal setting (setting #1) for most cutting needs. Use the high
speed setting (setting #2) for cutting through heavy hair. To start clipper
3