SPM NINA Manuel D'utilisation Et D'entretien page 56

- Moisten with water the rear of the tank where
it meets with the seal to facilitate the
reassembling procedures (see fig.26);
- Reassemble the bowl by positioning it back
into its seat until it gets blocked into it (see
fig.27).
- Re-insert the tap (fig.28) spreading Vaseline
on the O-rings to facilitate sliding the tap in its
seat until completely inserted.
!Warning!
If the tap does not perfectly slide into position,
the sealing hold will be endangered.
- Reassemble the drip tray.
Data di emissione: December, 2013 Revisione: 1
Fig. 26
Fig. 27
Fig. 28
Pag. : 56/68