Troubleshooting Guide - SPM Crathco MP Manuel D'utilisation Et D'entretien

12. TROUBLESHOOTING GUIDE

Problem
The appliance does not
cool, or cools
partially, and
compressor is running
The appliance does not
cool, or cools
partially, and
compressor is
running
The appliance is noisy
The main switch is in the
ON position but
appliance does not run
The appliance is running
and the top tank is filled
with liquid product but
nothing comes out of
the tap
The tap is leaking
The beater does not turn
The beater is noisy
during rotation
Buttons do not respond
to being pressed
Data di emissione: March, 2016
Possible cause
The space around the appliance is
•
only inadequate for ventilation
the The appliance is operating in wash
•
mode
The fan is not functioning
•
There is a loss of coolant
•
Electrical components
•
only compressor are not functioning
the Some electrical
•
not disconnected
Defective compressor
•
The beater and its components
•
have not been installed correctly
The fan blades
•
internal components
The front flange has not been
•
the positioned correctly
Some electrical
•
disconnected
The switch is broken
•
The electronic panel is defective
•
The agitator motor is defective
•
The pipe connecting the upper tank
•
with the lower freezing cylinder is
clogged
The mix in the cylinder is too dense
•
The tap has not been reassembled
•
correctly
The movement
•
impeded
The O-ring seals are damaged or
•
worn
The front flange is not mounted
•
correctly
Some electrical
•
disconnected
The electronic panel is defective
•
The agitator motor is defective
•
The beater, scrapers and/or rear
•
seals are not fitted correctly
The keypad is defective
•
The electronic panel is blocked or
•
defective
NOTE: The following procedures must
be performed by qualified technical
•
•
•
•
of the
•
•
connections are
•
•
are impacting
•
•
•
connections are
•
•
•
•
•
•
of the tap is
•
•
•
•
connections are
•
•
•
•
•
Revisione: 1
staff
Solution
Allow at least 20 cm of free space around
the appliance and place it away from
other heat sources
Turn on the cooling system by turning off
wash mode and activating cooling mode
Check the electrical
necessary replace the fan
Find the leak, eliminate it and recharge
the system
Replace non-functioning components
Check electrical connections
Replace the compressor
Dismantle the beater and reassemble the
parts correctly
Check and adjust
Correctly position the front flange
Check electrical connections
Replace the switch
Replace the electronic panel
Replace the agitator motor
Check and unclog the connecting pipe
Establish why the mixture
excessively, resolve the problem and
restart the appliance replacing the mix.
Dismantle and reassemble
correctly
Clean the tap and its housing and
lubricate with the Vaseline supplied
Replace the O-rings
Mount the front flange correctly
Check electrical connections
Replace the electronic panel
Replace the agitator motor
Remove and install the
components correctly
Replace the keypad
Turn the appliance off and on and if the
problem persists, replace the panel
Pag. : 35/56
connections, if
thickens
the tap
mixing unit