SPM Crathco MP Manuel D'utilisation Et D'entretien page 31

- Extract the beater and all components
mounted on it (fig. 18).
- Wash each of these components thoroughly
with hot water and washing-up liquid.
- Rinse well and dip each piece in the sanitising
product according to the doses and immersion
times suggested by its manufacturer (KAY-5
sanitizer suggest 1-2 minutes).
- Once the correct times for sanitising have
been followed, remove and dry all components
on a clean surface. DO NOT RINSE.
- Wash the freezing cylinder and top tank
thoroughly, removing any remaining product
with a clean sponge soaked with the sanitizing
solution making sure to completely wet all
surfaces for at least 60 seconds. Let air dry.
Follow local health ordinances (see figure 19).
- Remove the drip tray by pulling it gently
outwards (fig. 20)
- Wash it with hot water and mild dishwashing
detergent/soap and then rinse well.
Date of issue: September 2018 Revision 4
Fig. 18
Fig. 19
Fig. 20
Page 31/56