SPM Crathco MP Manuel D'utilisation Et D'entretien page 32

Once you have performed all these cleaning and
sanitising operations thoroughly, you can
reassemble the components.
The correct assembly of the appliance is very
important to prevent mix leakage and damage
to the appliance.
To assemble the appliance you must have an
approved lubricant (Vaseline) available.
Always make sure that all parts have been
properly washed and sanitised and that the
person carrying out the reassembly has
thoroughly washed and disinfected hands and
forearms.
- Insert the beater carefully into the cylinder
making sure that the rear shank fits perfectly in
its seat within the cylinder (fig. 21).
!ATTENTION!
During the insertion of the beater inside the
cylinder, grasp both the scrapers in order to
keep them in position during the insertion.
- Reassemble the parts of the dispensing tap,
making sure that the gaskets (J) are lubricated
with Vaseline grease so that the tap slides
smoothly back into its fixed position, until it's
completely inserted.
!Important!
The not perfect sliding of the tap
compromises its own seal.
- Carefully lubricate the sealing gasket of the
front flange and refit it back so that the locating
pin mates with its seat (fig. 22).
- Once you have correctly mounted the flange,
screw the security knobs right down tightening
them alternatively in order to avoid any risk of
wrong coupling.
- Place the drip tray back into their position.
- Once cleaned, before starting up the machine
perform the sanitizing procedure as described in
the next page.
Date of issue: September 2018 Revision 4
Fig. 21
Fig. 22
Fig. 23
Page 32/56