8. START-UP PROCEDURES AND
METHOD OF USE
!ATTENTION!
BEFORE STARTING THE APPLIANCE THE FIRST
TIME, CARRY OUT THE CLEANING AND
SANITISING PROCEDURES DESCRIBED IN
CHAPTER 9.
- Dilute and mix the product in a separate
container according to the manufacturer's
instructions (see fig.4); never pour dry powder,
crystals, or concentrate into a dry bowl.
Make sure that the mixture has a sugar content
near the 12-14%; a lower concentration could
seriously damage the mixing parts, as well as
the gear motors.
NEVER USE ONLY WATER.
!ATTENTION!
Never use the appliance with unsuitable
products different from the specific slush ones.
Failure to observe this instruction may cause
irreparable damage to components of the
appliance or causing unexpected performances
during the functioning.
- Remove the top tank lid (fig. 5).
- Pour the mix obtained into the upper tank
(fig.6) and wait until it has drained into the
freezing cylinder considering that the cylinder
capacity is almost 8 litres while the upper tank
one is almost 10.
Date of issue: September 2018
Caution
Revision 4
Fig. 4
Fig. 5
Fig. 6
Page 25/56