BENE LEVEL LIFT Mode D'emploi page 8

SAFETY INSTRUCTIONS
Never attempt to open the enclosure of the
12
control unit or the power supply unit. Unau-
thorised opening of the enclosure and improper
repairs can cause danger and voids the warranty.
Only professionals authorised by the manufac-
13
turer may carry out any maintenance or repara-
tions.
Do not operate devices in explosive environ-
14
ments.
This furniture is only certified for commercial
15
office and administrative areas within rooms.
The manufacturer assumes no liability for dam-
16
age resulting from improper use.
Connection plug boards must be fixed prop-
17
erly for easy plugging and unplugging. Plugs and
connection plug boards must be located in such a
way that no fluids come into contact with electri-
cal equipment when the office furniture is used
properly.
The power cable must be secured in the strain
18
relief. Interconnecting cables may be run loosely.
All lines and cables must be run in such a man-
ner as to avoid mechanical damage (i.e., shear-
ing, abrasion,...).
If the furniture has movable or heightadjust-
19
able parts, then particular care must be taken:
Cables must be sufficiently long to allow height
adjustments without damaging the cables and
wiring (i.e., stretching, crushing, ...).
If the electrical cable of this device is dam-
20
aged, it must be replaced by the manufacturer or
by its customer service or by a similarly qualified
person to avoid risks.
Do not spill liquids into control unit or power
21
supply unit to avoid electrical shock or short cir-
cuits.
The operation of the control mechanism and
22
the power supply unit requires a minimum of 5°C
and a maximum temperature of 40°C.
8 8