Technical Specification; Accessories - Eurosystems Euro5RG EVO Mode D'emploi

(2) and unscrew the cap (3). The oil discharge should be performed when the machine is still hot. When your discharge is finished , screw the cap
again (3) and supply with new oil from the upper hole (A) and put the small rod again. (1) .
MOTOR-HOE OIL CHANGE ( Fig. 17)
(only when engine/gear box is working using a hot device). As a general rule the oil should be
EN
changed after every 100 work hours (oil viscosity SAE 80). To change oil: a) Remove the spur. b) Unscrew the screw cap (1). - c) Tilt the machine
and intake the oil through a syringe. - d) Pour in about 0,5 l. of new oil. Tilt the machine to check that level is correct. The oil should begin to flow from
the hole just before the machine touches the ground (with point A) - e) Replace the filler screw cap (1).
ATTENTION! The used oil must not be drained into the sewer system or waterworks. In order to prevent any pollution to the water-table. Most garages
have used oil deposits, or use the authorized deposits according to your local authority regulations.
GARAGING AND SCHEDULED MAINTENANCE (Fig.19)
Keep attention that all the nuts, screws and bolts are tightened in order to
guarantee a good machine working on safety conditions. Leave the machine to cool before garaging anyhow don't room it if the tank contains still
contains some fuel as the vapours could reach some blazes or sparks. To lower the fire danger , keep the engine , the silencer and the fuel area free
from leaves , grass or greasy substances. Periodically check the tightness of the handlebar (1) to the support (2). If the tightening is not guaranteed,
please lower the lever (3) and tighten the nut (4).
DESCRIPTION OF CONTROLS (Fig. 18)
1. Throttle lever - 2. Tilling gear control lever (safety device) - 3. Tilling adjustment spur (single
position) - 4. Cultivator rotavator ( with widening tines) - 5. Knobs handlebar/frame - 6. Handlebar - 7. Transport Wheel - 8. Rotavator repair/cover -9.
Gearbox - 10. Recoil starter (self-winding device) 11. Motor. – 12. Lock/release lever for handlebar – 13. Handlebar support - 14 Gear connection
lever.

TECHNICAL SPECIFICATION

Engine: consult the specific publication for information. Transmission: by gears ,chain in oil bath and belt .
Gearbox : Mechanical gearbox 2 speeds forward + reverse, into an aluminium housing. Speed :1^ forward speed 97 rpm 2^ forward speed 125 rpm
and reverse 29 rpm. Tiller : fitted with interchangeable tines. Working width 75 cm. with protection case and tree saver disks. Rotavator diameter :
Ø 320 mm. Tilling depth : 240 mm. Max width: 0,75 m. Height: 1,00 m.
NOISE AND VIBRATION LEVEL
Measured sound pressure level with En709, Leq = 88,5 dB (A), with a uncertainty value K = ±0,8 dB (A).
Measured sound power level with En709, Lwa = 96,1 dB (A), with a uncertainty value K = ±0,9 dB (A).
Handlebar vibration in compliance with EN 709 and ISO 5349. Level max detected = 5,39 m/s , uncertainty value K = ±0,36 m/s .
2 2

ACCESSORIES:

Ridging plough , De-Thatcher and Adjustable spur.
22