Sirius SNOOP Instructions D'utilisation page 16

MAINTENANCE
An accurate maintenance guarantees good
functioning and long-lasting performance.
Particular care is due to the grease filter.
It can be removed by following the instruc-
tions below:
The grease filter is fixed through magnets,
there fore it is sufficient to insert a hand tool
or the tip of a knife in the dedicated opening
and push upwards in order to pull the filter
out of its place. See Fig. 12. In order to remo-
ve the filter from the hood, unhook the two
security cables opening their snap-hooks,
The active coal filter has to be removed after
the extrac tion of the grease filter by pusing
the specific handle (fig.8).
The grease filter needs cleaning by regular
hand-washing or in dishwashers ev ery two
months at least or depending on its use.
The active coal filter needs to be periodically
replaced.
The charcoal filter is removed by removing
the grease filter first, following the instruc-
tions above.
To clean the appliance itself tepid water and
neutral detergent are recommended, while
abrasive products should be avoided.
The power cord shall be replaced by authori-
zed personnel only.
Substitution of the LED bar:
Using an appropriate tool, remove the LED
bar from its seat (refer to Fig. 7), disconnect
it electronically using the appropriate con-
nector then substitute it with a LED bar with
same characteristics.
16