DJO Global ARTROMOT-S3 Série Mode D'emploi page 79

13. Place the ARTROMOT®-S – legs down
– on the bottom of the box. The mark-
ings on the bottom of the box indicate
the correct position.
14. Then put the enclosed polystyrene
block on the chair, observing the cut-
outs in the block.
15. Put the programming unit (1) in the
supplied box. Place the motion ele-
ment, the armrest, the components
of the neck and shoulder restraint and
the power cord in the respective cut-
outs in the polystyrene block.
16. Then close the box.
Reverse the above steps to reassemble the
device after transport.
_________________
¹ Only with ARTROMOT®-S comfort
Warning!
Shock hazard – Before use allow the
ARTROMOT®-S to reach room temper-
ature. If the device has been transported
at temperatures below 0 °C (32 °F),
leave it to dry at room temperature for
about 2 hours, until any condensation
has disappeared.