Makita DC40RB Manuel D'instructions page 7

CAUTION:
Carefully choose a stable wall for mounting the charger. Make sure there is no hindrance
to mounting work or charging operation. The gross weight of the charger and battery reach approximately
5.0 kg (11 lbs). Provide sufficient reinforcement for the wall if necessary.
CAUTION:
Be careful not to drop the battery cartridge when inserting or removing the battery from the
wall-mounted charger. Hold the battery cartridge firmly and keep a stable posture.
You can mount the charger on the wall. Make a clearance around the charger as shown in the figure.
► Fig.3
NOTE: Things you need to prepare:
— Four screws - two for hanging and two for anchoring
Screw size : 6 mm x more than 40 mm.
Screw head size : Less than ø12 mm.
— Tools - for tightening screws
1.
Fix two screws for hanging on the wall.
2.
Remove the rubber feet (four pieces) from the bottom of the charger.
3. Hang the charger with the screws fixed in step 1.
► Fig.4
4. Mount the charger on the wall by tightening two anchoring screws completely.
► Fig.5
7 ENGLISH