Technical Data - Okay KSE 2300-40 Manuel D'utilisation

Electric Chainsaw
Introduction to the Operating Instructions
These Operating Instructions are intended to facilitate your becoming acquainted with the machine and using it in
accordance with the regulations. The Operating Instructions contain important information on how to use the machine
safely, correctly and economically. Observing this information will help increase the reliability and working life of the
machine. The Operating Instructions must always be at hand when the machine is being used.
They must be read and observed by every person dealing with the machine, whether operating, servicing or transporting it.
In addition to the Operating Instructions and the applicable rules of the prevention of accidents valid in the country
of use and on site, the generally recognised rules on working safely and correctly must be observed as well as the
accident prevention rules of the relevant professional associations.

Technical Data

The devices are manufactured in accordance with the provisions of DIN EN 60745-2-13 and fully comply with the
provisions of the German Product Safety Act.
Electric Chainsaw
Rated Voltage
Nominal Frequency
Fuse (time lag)
Rated Output
Guide Bar
Cutting length
Speed
Weight
Oil
All models with automatic chain lubrication and mechanical chain brake and rundown brake.
The type designation of the chain you will find on the type plate.
Class of Protection:
Interference Suppression:
Noise emission information in accordance with the German Product Safety Act (ProdSG) and the EC Machine Direc-
tive:
Noise emission values EN-60745:
Vibration values in accordance with EN 60745:
Attention: This chain saw is only intended for cutting wood !
Emissions
- The specified vibration emission value was measured by a standardized test methods and can compare with other
power tools are used.
- The specified vibration emission value can also be necessary for the assessment of work breaks are used.
- The specified vibration emission value can vary during the actual use of the electric tool by specifying the value,
depending on the way how to use the power tool.
- Note: You create the privilege against vascular pulsations of the hands in time breaks
- Try to keep the stress due to vibration as low as possible. For example, measures to reduce vibration stress are
wearing gloves when using the tool and limiting the work time. All phase of the operating cycle must be considered
in this regard, (for example, times when the power tool is switched off, and times when the power tool is switched
on but is not running under load).
GB | Operating Instruction
KSE 2300-40
V~ 230
Hz 50
A 16
W 2300
mm 400
mm 380
m/sec ca. 12
kg 4,7
ml 200
II/ DIN-EN 60745-1
according to EN-55014
Sound Pressure Level L
Weighted acceleration handle
GB-2
90 dB (A) [K=3,0 dB (A)]
pA
max. 6,1 m/s [K=1,5 m/s
2
]
2