Dometic Heki 4 Plus Instructions De Montage Et De Service page 13

Installing the Heki4 Plus
See fig. e
➤ Plug the (1) outer frame coupling into the circuit board contact (2) in the inner
frame.
A
NOTICE!
Make sure the polarity is correct:
• Red cable: positive terminal
• Brown cable: earth
➤ Connect the vehicle's 12 V power supply line (3) to the cable of the roof
window (4).
➤ Make sure the lamps are fitted securely.
➤ Check the functions of the window:
– Open the roof light (see chapter "Opening the roof light" on page 13).
– Close the roof light (see chapter "Closing the roof light" on page 13).
– Switch the lighting on and off (see chapter "Switching the lighting on and off"
on page 14).
If faults occur: see chapter "Troubleshooting" on page 15.
See fig. f
➤ Clip on the ventilation grille (1).
It needs to click in.
➤ Clip the lamp covers (2) on the lamps.
They need to click in.
➤ Remove the protective film from both sides of the acrylic glass.
I
NOTE
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
➤ If necessary, enter the new vehicle height and weight in the vehicle documents.
10
Heki4 Plus
EN