Specifications - Monacor International JTS UF-20TB/5 Mode D'emploi

3) Press the button  to go to the setting
, i e the muting function is not
& Power
locked
4) After selection, use the button SET to go to
the line
Lock OFF
OFF
5) Press the button  to activate the key lock
(ON)
6) Press the button SET to save the setting
When a button is pressed, the following mes-
sage appears:
Press Set
for 2 Sec.
to unlock
keypad.
When the switch MUTE (8) is used while
selected, the following message appears:
Lock ALL
Mute
function is
disabled.
Notes:
1 When the key lock is activated and the menu is
deactivated, the symbol
2 The key lock can also be activated or deactivated di-
rectly on the receivers UF-20R / 5 and UF-20S / 5 via the
REMOSET function (refer to the instruction manual
of the receivers)
– Deactivating the lock –
1) Keep the button SET pressed for two seconds
until the menu
KeyLock
ALL
Lock ON
2) Press the button SET once again so that
appears in the lower line
OFF
3) Press the button  to select the setting
and press the button SET to save the setting
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
18
The line indicates
appears on the display
appears
KeyLock
Fig. 17
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®

4 Specifications

Set
Carrier frequency range: 530 – 605 MHz
Frequency stability:
Transmission power (EIRP)
ON/
Low:
High:
REMOSET frequency:
Audio frequency range: 50 – 18 000 Hz
Low-cut filter:
Ambient temperature: 0 – 40 °C
Power supply:
Operating time:
is
ALL
Dimensions
(W × H × D):
Weight:
Microphone
connection:
1
4
2
3
Fig. 18 Microphone jack
1 = ground
2 = 5 V operating voltage for the microphone
3 = signal input
4 = impedance correction
ON/
OFF
Subject to technical modification
±0 005 %
10 mW
50 mW
2 4 GHz
100 Hz, 18 dB / octave
2 (rech ) batteries
of size AA
> 20 h with
3400 mAh rech bat-
teries
62 × 170 × 23 mm
90 g
4-pole mini XLR jack