Setting The Transmission Frequency; Remoset Function - Monacor International JTS UF-20TB/5 Mode D'emploi

Light Time
15 Sec.
= no backlight
Always OFF
– = time in seconds
5 30 Sec.
= backlight always on
Always ON
Hint: To save the batteries, it is advisable not to use
as a permanent setting
Always ON
3) Via the menu item
name can be entered (10 characters max )
which appears on the display (e g UF-20TB
as shown in Fig 2) When multiple trans-
mitters are used, this will make it easier to
distinguish between the transmitters and to
identify them After the menu item
has been called up, the first character
Name
position is selected:
User Name
U F-20TB
Char:1/10
Fig. 6
Press the button  or  to select the de-
sired character Press the button SET to go
to the next character position After setting
the name, press the button SET repeatedly
until the display indicates
menu reappears
4) For a reset to the factory settings, select the
menu item
Reset
A message appears to warn you that reset-
ting will erase any data stored:
All stored
data will be
erased.
Yes / No
Fig. 7
To cancel the process, retain the option
and press the button SET; to reset, use the
button  to select
ton SET

3.7 Setting the transmission frequency

Before switching on the pocket transmitter, set
the receiver to an interference-free frequency
(refer to the instruction manual of the receiver)
Then set the transmitter to the same frequency:
There are three methods to do this:
Fig. 5
, a device
User Name
User
The main
Saving
and press the button SET
and press the but-
Yes
1 If you operate the pocket transmitter together
with the receiver UF-20R / 5 or UF-20S / 5, the
easiest way is to use the patented REMOSET
function When you press the button REMO-
SET on the receiver, the transmitter is set to
the transmission frequency selected on the
receiver (chapter 3 7 1)
2 The transmission frequency can be ad-
justed manually between 530 000 MHz and
605 000 MHz (chapter 3 7 2)
3 For operating multiple audio transmission sys-
tems at the same time, there are 15 groups
with up to 63 channels in each group (refer
to the table starting on page 38) In ideal
conditions, all channels from a group can be
used for audio transmission at the same time
If the receiver has been set to a channel from
these groups, select the same channel for the
pocket transmitter (chapter 3 7 3)

3.7.1 REMOSET function

For the REMOSET function always make sure
that
1 no menu is called up on the pocket transmit-
ter or on the receiver
2 the transmitter is switched on and close to
the receiver (REMOSET transmission range:
approx 10 m)
3 the transmitter and the receiver are set to
the same identification number (ID No ) or
that the function ID No is deactivated (see
paragraph "Identification number")
4 the REMOSET function is not disabled (see par-
agraph "Disabling the REMOSET function")
5 the receiver and the pocket transmitter are
not locked (chapter 3 12)
No
6 the microphone connected is not muted
(chapter 3 11)
– Identification number –
To prevent mutual interference of individual
pairs of transmitter / receiver during REMOSET
transmission, each pair must have a different
identification number (ID No ) If you only use
one pair of transmitter / receiver, there is no need
to change the preset ID No 1 To change the
ID No :
15