Publicité
Les langues disponibles
Les langues disponibles
700CS/715CS/700CS EPT/715CS EPT NEW CONSTRUCTION INSTALLATION
1
Mark frame location (using holes).
1a
Open hinge and place frame leaf flat against surface of
frame leaving Z\," gap between top of hinge and frame
header, and Z\zn" gap between edge of hinge and stop.
1b
Mark center of each HOLE using center punch.
Holes
L DO NOT attach hinge to frame at this time.
2
Mount hinge to door (using holes).
2a
Place door leaf of hinge against hinge edge of door so
that top of hinge is flush with top of door and edge of
hinge leaf is flush with inside face of door.
2b
Mark center of each HOLE with center punch.
Holes
2c
With hinge held firmly in place, use #12-24 x 3/4"
self-drilling tapping screws to fasten leaf to door.
L #16 pilot drill is recommended for all holes.
L Fasten top screw first, and bottom most screw second,
making sure hinge is aligned correctly.
2d
Install screws into remaining HOLES.
3
Mount door to frame (using holes).
3a
Move door (with hinge attached) into opening and align
mounting holes in frame leaf with marks in frame made in
Step 1 above.
L An angle block, jack, or shims will be helpful in positioning the
door properly.
3b
With hinge and door held firmly in place, use #12-24 x 3/4"
self-drilling tapping screws to fasten the frame leaf of hinge
to the frame using the HOLES.
L #16 pilot drill is recommended for all holes.
700CS shown
#16
700CS shown
Holes
#16
A
¹⁄₁₆"
(1.6 mm)
¹⁄₈"
(3.2 mm)
A
B
Flush
Flush
B
A
Flush
Flush
For model 715CS,
edge guard pushes
up against door for
alignment.
5
Publicité
