Publicité
Les langues disponibles
Les langues disponibles
1
Mark frame location (using slots).
1a
Open hinge and place frame leaf flat against surface of
frame leaving Z\," gap between top of hinge and frame
header, and Z\zn" gap between edge of hinge and stop.
1b
Mark center of each HORIZONTAL SLOT using center
punch.
Slots
L DO NOT attach hinge to frame at this time.
2
Mount hinge to door (using holes).
2a
Place door leaf of hinge against hinge edge of door so that top of hinge is
flush with top of door and edge of hinge leaf is flush with inside face of door.
2b
Mark center of each HOLE with center punch.
2c
With hinge held firmly in place, use #12-24 x 3/4" self-drilling tapping screws
to fasten leaf to door.
L #16 pilot drill is recommended for all holes.
L Fasten top screw first, and bottom most screw second, making sure hinge is
aligned correctly.
2d
Install screws into remaining HOLES.
3
Mount door to frame.
3a
Move door (with hinge attached) into opening
and align horizontal slots in frame leaf with
marks in frame made in Step 1 above.
L An angle block, jack, or shims will be helpful in
positioning the door properly.
3b
With hinge and door held firmly in place, use
#12-24 x 3/4" self-drilling tapping screws to
fasten the frame leaf of hinge to the frame using
the HORIZONTAL SLOTS.
L #16 pilot drill is recommended for all holes.
700CS AFTERMARKET INSTALLATION
Holes
Slots
#16
A
¹⁄₁₆"
(1.6 mm)
¹⁄₈"
(3.2 mm)
A
B
Flush
#16
A
B
Flush
3
Publicité
