After The Ride; Maintenance; Troubleshooting - XciteRC X-Dive micro Série Mode D'emploi

EN
Drive
Press the forward-/reverse or left-/right button to control the submarine.

After the ride

Take the submarine out of the water and switch off by open the waterproof switching cover.
WARNING: remove the transmitter batteries when transmitter not in use – fire and explosion hazard!

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• The X-Dive micro U-Boot is waterproof, yet it may happen that a few drops of water gets lost into the boat.
Therefore check after every ride if water is inside in the hull and release it when necessary.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.

Troubleshooting

Problem
Transmitter does
not work
Boat did not dive
The X-Dive micro
U-Boot
does not react on
the transmitter
The X-Dive micro
U-Boot
gets out of control
or stops suddenly
Runtime very short Weak battery, almost empty
18
After the ride · Maintenance · Troubleshooting
Possible Cause
No batteries inserted
Polarity of the batteries reversed
Put it wrongly into the water
Transmitter does not work
Drive battery is almost empty
Boat outside the maximum range
Water in the submarine
Motor worn/defective
Propeller blocked ie. with water plants
Corrective Action
Place 6 x AA batteries into the transmitter
Check polarity of the inserted batteries,
and correct if necessary
See chapter „Dive"
See "Transmitter does not work"
Recharge battery according to the inst-
ructions
Observe the maximum range (3-5 m)
See chapter „Drive"
Recharge battery according to the inst-
ructions
Check, replace if necessary
Clean the propeller
X-Dive micro U-Boot