R&G LP0289BK Instructions De Montage page 10

Page 10 of 25
If using Mini indicators
• If using mini's fit the indicators of choice to the indicator/licence plate mounting bracket
(item 1) (R&G mini indicator product code RG371 for LED type or RG372 for Aero Style led
type) using the four indicator adaptors (item 2) as shown in the pictures below and tighten
the nut.
• Feed the indicator wiring through one of the nut/wire covers (item 11) as shown in
pictures below (it helps if a small amount of liquid detergent is used) and position the nut
cover over the nut (repeat the above for the opposite indicator).
• Fit one length of heat-shrink (item 14) over the wires of each indicator so the heat-shrink
fits over the stem of the nut/wire cover and gently heat until the heat-shrink contracts to
the wiring and nut/wire cover as shown in pictures below.
• Fit the new licence plate illuminator (item 16) to the new licence plate bracket (item 1) as
shown in pictures 21 and 22.
• PLEASE NOTE YOU WILL NEED TO GLUE THE LIGHT SHROUD TO THE LED LICENCE
PLATE ILLUMINATOR USING A SUITABLE ADHESIVE.
• Use the cable ties and clips (items 3 and 12) to neaten and tidy the wiring as shown in
picture 23 ensuring to leave room around the slot for bolts and washers when fully
assembled.
• Stick the self-adhesive neoprene foam (item 13) to the mounting bracket (item 18) as
shown in picture 24.
• Using the three short M6 button head bolts (item 19) with the larger washers (item 17)
mount the main mounting bracket (item 18) to the indicator/licence plate bracket assembly
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G
www.rg-racing.com
LP0289BK
Email: info@rg-racing.com