Speakerphone Volume Setting - Geemarc PhotoPHONE 100 Mode D'emploi

Pressing the Amplify button
additional amplification and tone controls. However, you can still
adjust the handset receive volume with the Volume slide bar.
Irrespective of how many times you press the amplify key
throughout a call, the next time you pick up the handset to make a
new call, these functions will be activated once again.
AMPLIFY ON/OFF Switch at OFF Position
The additional amplification and tone controls are deactivated
each time you use the telephone. The Amplify LED will be off
whenever you use the telephone.
Pressing the Amplify button
tone control and additional amplification. The LED light will turn on
to reflect this change. If you press the amplify button
more, the additional amplification and tone control features will be
turned off once again. The LED light will turn off to reflect this
change.
Irrespective of how many times you press the amplify key
throughout a call, the next time you pick up the handset, these
functions will be turned off once again.
Tone Receiving Adjustment
If the receiver volume has been amplified, the tone control
the low frequency or high frequency sounds with the tone slide
control on the top of the unit.
Note: The tone adjustment function will not be affective when the
receiver volume is set to normal level.

Speakerphone Volume Setting

In hands free mode you can adjust the speaker volume by using
the volume controls V+ or V- located on the right side of the
phone.
SETTINGS SETTINGS
can also be adjusted. You can adjust and increase
during a call will turn off the
once during a call will enable
8
once