Silver 5/8" Machine Screw - Sauder 403932 Instructions De Montage

Step 21
With someone's help, carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the right diagram. If
å
it isn't, loosen the mounting screw to slide it against the stops. Then tighten the mounting screw.
Fasten the DOOR (S) to the LEFT UPRIGHT (G). Use the screws in the HINGES. See the next step for adjustments.
å
Peel the FELT DISCS from the FELT DISC CARD (RR). Stick a FELT DISC on the DOOR where it comes in contact with the
å
CENTER UPRIGHT (H).
Fasten a PULL (OO) to the DOOR (S). Use two SILVER 5/8" MACHINE SCREWS (YY).
å
Repeat this step for the other DOOR (S).
å
Hinge
www.sauder.com/services
Stop
Mounting
screw
RR
OO
S
RR

SILVER 5/8" MACHINE SCREW

G
H
YY
(4 used for the PULLS)
403932 Page 25